Husqvarna P524 EFI Workshop Manual page 73

10. Remove the belt guard in front of the rear
transmission.
11. Remove the belt from the engine pulley.
12. Remove the belt guard on the right side of the
machine.
13. Pull the front part of the belt out through the right
side of the articulation of the product.
14. Remove the belt from the hook on the center pulley.
15. Pull the drive belt out.
662 - 001 - 23.10.2018
16. Attach a new drive belt in the opposite sequence.
Make sure that the drive belt for the cutting deck is
attached as the illustration shows. Make sure that it is
put correctly in the adjuster pulley, identified by an arrow
in the illustration.
9.10.2 To replace the V-belt on the cutting deck
WARNING: Risk of crush injury. Use protective
gloves.
1. Remove the cutting deck. Refer to
cutting deck on page 63 .
2. Open the lock for the track rod bolt.
3. Remove the 2 bolts that hold the lock bracket on the
cutting deck frame.
4. Remove the lock bracket and remove the cutting
deck frame.
To remove the
Repair instructions - 73