Husqvarna P524 EFI Workshop Manual page 59

15. Remove the transmission out of the frame.
WARNING: The transmission is heavy.
16. Assemble in opposite sequence.
Note: If you replace the transmission, move the
hydraulic connection adapters to the new transmission.
You must also move the adjustment devices to the new
Wheel speed on page 61 .
transmission. Refer to
662 - 001 - 23.10.2018
9.6.4 To disassemble and assemble the speed
adjustments of the rear transmission
1. Remove the screw (A), nut (D), spring (E) and
washer (F) from the device for the slewing speed
adjustment.
K
H
2. Remove the nut (B) and the link head (C).
3. Remove the adjustment screw (G).
4. Remove the nut (H) and screw (I).
5. Remove the nut (J) and the link head (K).
6. Assemble in opposite sequence.
9.6.5 To disassemble the front transmission
1. Remove the tool frame. Refer to
equipment frame on page 69 .
2. Remove the left footrest plate. Refer to
the covers on page 23 .
3. Put support below the product.
4. Remove the wheels and wheel hubs. Refer to
disassemble and assemble the wheel hub on page
26 .
A
J
I
G
E
C
F
D
To disassemble the
To remove
To
Repair instructions - 59
B