Husqvarna P524 EFI Workshop Manual page 58

8. Loosen the rear end of the control stay (A) from the
linkage (B). Remove the nut (E), screw (C) and
bushing (D).
F
G
H
9. Loosen the front end of the control stay (A). Remove
the nut (G), screw (F) and washer (H).
10. Remove the 2 screws that hold the bearing unit on
each side of the transmission.
58 - Repair instructions
B
E
D
A
11. Remove the stop screws.
C
12. Remove the bearing unit.
13. Remove the joint screw.
14. Remove the 3 screws that hold the transmission.
662 - 001 - 23.10.2018