Husqvarna P524 EFI Workshop Manual page 71

9.9.3 To replace the joint bearing of the steering
cylinder
1. Remove the snap ring (C).
B
A
2. Push out the joint bearing of the steering cylinder (B)
in the direction of the snap ring side.
3. Clean the bearing seat (A).
4. Apply a thin layer of lubricant on the walls of the
bearing seat.
5. Push in the joint bearing from the snap ring side.
Push only on the outer bearing ring.
6. Attach the snap ring.
9.9.4 Power stering servo connections
E = Power beyond
T = Tank
P = Pressure
L = Left
R = Right
662 - 001 - 23.10.2018
C
9.9.5 To replace the power steering servo
1. Remove the 2 screws and remove the steering
column cover.
2. Disconnect the headlight connection (A).
A
3. Remove the steering wheel hub (E).
D
C
A
4. Remove the steering wheel screw (F) and washer
(G).
5. Remove the steering wheel (D). Use a puller if it is
necessary.
6. Remove the key (C).
E
F
G
B
Repair instructions - 71