Husqvarna P524 EFI Workshop Manual page 52

3. Remove the clamp on the front end of the
hydrostatic transmission cable.
4. Remove the front ball joint from the hydrostatic
transmission cable.
5. Disconnect the ball joint from the lever on the
hydraulic pump.
52 - Repair instructions
6. Remove the clamp on the rear end of the hydrostatic
transmission cable.
7. Remove the hydrostatic transmission cable.
8. Remove the rear ball joint from the hydrostatic
transmission cable.
9. Assemble in opposite sequence.
9.5.15.2 To adjust the hydrostatic transmission
cable
1. Remove the locking spring of the ball joint.
2. Push the forward pedal fully down.
662 - 001 - 23.10.2018