Husqvarna P524 EFI Workshop Manual page 50

9.5.13 To replace the hydraulic oil tank
1. Remove the side cover of the control panel and the
right footrest plate. Refer to
on page 23 .
2. Remove the protection cover from the right side of
the machine.
3. Put a container below the drain plug for the hydraulic
oil tank.
4. Remove the drain plug for the hydraulic oil tank.
5. Make marks on the 3 hoses to make it easier to
attach them correctly.
6. Clean the hydraulic connections. Refer to
the hydraulic system clean on page 44 .
7. Remove the 3 hydraulic hoses and put protection
caps on the hoses and connections.
8. Remove the 2 screws.
9. Remove the operator seat. Refer to
and assemble the seat on page 24 .
50 - Repair instructions
To remove the covers
To keep
To disassemble
10. Remove the 2 screws from the cable retainers and
the 4 screws in the frame section below the operator
seat.
11. Disconnect the PTO button connection from the
circuit board.
12. Remove the screw that holds the circuit board and
move the circuit board to the side.
13. Remove the knob on the throttle control and the
knob on the height adjustment control.
14. Remove the nut to remove the lever for the valve
block from below.
15. Remove the control panel.
662 - 001 - 23.10.2018