Pre-Start Inspection - JLG 600S Operation And Safety Manual

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION

Pre-Start Inspection

The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel, or bat-
tery fluid) or foreign objects. Report any leakage to the
proper maintenance personnel.
2. Structure - Inspect the machine structure for dents, dam-
age, weld or parent metal cracks or other discrepancies.
Parent Metal Crack
3. Decals and Placards – Check all for cleanliness and legibil-
ity. Make sure none of the decals and placards are missing.
Make sure all illegible decals and placards are cleaned or
replaced.
4. Operation and Safety Manuals – Make sure a copy of the
Operation and Safety Manual, AEM Safety Manual (ANSI
markets only), and ANSI Manual of Responsibilities (ANSI
markets only) is enclosed in the weather resistant storage
container.
2-6
10.
Weld Crack
11.
12.
5. Walk-Around Inspection – Refer to "Walk-Around Inspec-
tion" on page 7.
6. Battery – Charge as required.
7. Fuel (Combustion Engine Powered Machines) – Add the
proper fuel as necessary.
8. Engine Oil Supply – Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9. Hydraulic Oil – Check the hydraulic oil level. Ensure hydrau-
lic oil is added as required.
Accessories/Attachments – Refer to the Accessories section
in this manual or the accessory installed upon the machine
for specific inspection, operation, and maintenance instruc-
tions.
Function Check – Once the "Walk-Around" Inspection is
complete, perform a functional check of all systems in an
area free of overhead and ground level obstructions. Refer to
Section 4 for more specific operating instructions.
Platform Gate – Keep gate and surrounding area clean and
unobstructed. Verify the gate closes properly and is not bent
or damaged. Keep gate closed at all times except when
entering/exiting the platform and loading/unloading mate-
rials.
31215033