Walk-Around Inspection - JLG 600S Operation And Safety Manual

Walk-Around Inspection

Begin the "Walk-Around Inspection" at Item 1, as noted on the
diagram. Continue checking each item in sequence for the con-
ditions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF. DO NOT OPERATE
MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING THIS
AREA MAY RESULT IN DISCOVERY OF CONDITIONS WHICH COULD CAUSE EXTENSIVE
MACHINE DAMAGE.
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, that they are securely fastened, and no visi-
ble damage, leaks or excessive wear exists in addition to any other
criteria mentioned.
1. Platform Assembly and Gate - Footswitch works prop-
erly, not modified, disabled or blocked. Gate latches and
hinges in working condition.
2. SkyGuard - See Inspection Note.
31215033
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3. Platform Control Console - Switches and levers return to
neutral when activated and released, decals/placards
secure and legible, control markings legible.
4. Platform Rotator - See Inspection Note.
5. Jib Assembly and Jib Rotator (If Equipped) - See Inspec-
tion Note.
6. Boom Sections/Uprights/Turntable - See Inspection
Note.
7. All Hydraulic Cylinders - No visible damage; pivot pins
and hydraulic hoses undamaged, not leaking.
8. Wheel/Tire Assemblies - Properly secured, no missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepan-
cies. Inspect wheels for damage and corrosion.
9. Drive Motor, Brake, and Hub - No evidence of leakage.
10. Tie Rod Ends and Steering Spindles - See Inspection
Note.
11. Counterweight - See Inspection Note.
12. Ground Control Console - Switches and levers return to
neutral when activated and released, decals/placards
secure and legible, control markings legible.
2-9