JLG 600S Operation And Safety Manual page 57

TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CONTROL LEVERS OR
TOGGLE SWITCHES CONTROLLING PLATFORM MOVEMENT DO NOT RETURN TO THE
OFF OR NEUTRAL POSITION WHEN RELEASED.
1. Drive Speed/Torque Select Switch
The forward position gives maxi-
mum drive speed. The back posi-
tion gives maximum torque for
rough terrain and
grades. The center
allows the machine to be driven
as quietly as possible.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR SLIGHT LEVELING OF
THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/OCCUPANTS TO SHIFT OR
FALL. FAILURE TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
31215033
climbing
position
SECTION 3 - MACHINE CONTROLS AND INDICATORS
2. Platform Leveling Override
A three position switch allows the operator to
adjust the automatic self leveling system. This
switch is used to adjust platform level in situa-
tions such as ascending/descending a grade.
3. Fuel Select (Dual Fuel Engine Only) (If
Equipped)
Moving the switch to the appropriate position
selects gasoline or liquid propane fuel.
4.
Horn
A push-type HORN switch supplies electrical power to an
audible warning device when pressed.
5.
Power/Emergency Stop Switch
A two-position red mushroom shaped switch
furnishes power to PLATFORM Controls when
pulled out (on). When pushed in (off ), power is
shut off to the platform functions.
6. Start/Auxiliary Power
When pushed forward, the switch energizes the
starter motor to start the engine.
3-17