JLG 600S Operation And Safety Manual page 59

10. Lights (If Equipped)
Operates accessory light packages if the
machine is so equipped.
11.
Jib Lift (If Equipped)
Provides for raising or lowering of the jib by
positioning up/down.
12.
Soft Touch/SkyGuard Override Switch
For machines equipped with SkyGuard:
The SkyGuard override switch enables
functions cut out by the Skyguard sys-
tem to be operated again, allowing the
operator to resume use of machine
functions.
For machines equipped with both SkyGuard and Soft Touch:
The switch operates like the SkyGuard
override switch as described above.
The switch also enables the functions
cut out by the Soft Touch system to
operate again at creep speed, allowing the operator to move
the platform away from the obstacle that caused the shut-
down situation.
31215033
SECTION 3 - MACHINE CONTROLS AND INDICATORS
13. Soft Touch/SkyGuard Indicator
Indicates the Soft Touch bumper is against an object or the
SkyGuard sensor has been activated. All controls are cut out
until the override button is pushed. For Soft Touch, controls
are then active in the Creep Mode or for SkyGuard, controls
will work normally.
When Soft Touch is active, the indicator will be on continu-
ously and the alarm will sound. When SkyGuard is active, the
indicator will flash, and the horn will sound continuously.
14.
Platform Rotate
Provides rotation of the platform when posi-
tioned to the right or left.
15.
Function Speed Control
This control affects the speed of telescope
and jib lift (if equipped). Turning the knob
all the way counterclockwise until it clicks
puts drive and swing into creep mode.
3-19