Rack Mounting Requirements; Rack Mounting Procedure - Extron electronics Quantum Ultra Series User Manual

Rack Mounting Requirements

In addition to the UL guidelines (see "UL Guidelines for Rack Mounting"), observe the
following when mounting the processor:
Support
Always use additional support at the sides or rear of the Quantum Ultra unit, attached to
both the front and rear rack posts. Ensure that the shelf or other mounting accessories
can support the full weight of the unit.
ATTENTION:
• Do not rely on the processor mounting flanges to support the full weight of the
unit. These must be used only to secure the unit within the rack.
• Veuillez ne pas utiliser les brides de montage du processeur pour le support du
poids total de l'unité. Celles-ci doivent être utilisées uniquement pour fixer l'unité
dans le rack.
• Do not stand other units directly on top of the processor when it is rack
mounted because this can overload the mountings.
• N'installez pas d'autres produits directement au-dessus du processeur lorsque
celui-ci est monté en rack : cela risquerait de surcharger les éléments de
montage.
Ventilation
Ensure that sufficient airflow is provided to satisfy the ventilation requirements of all items
of equipment installed in the rack.
A ventilation gap of at least 4 inches (10 cm) must be left between the side panel vents of
the Quantum Ultra and adjacent surfaces or equipment.

Rack Mounting Procedure

The Quantum Ultra processors are housed in rack-mountable metal enclosures with
mounting flanges for standard 19-inch racks.
Mount the Quantum Ultra as follows (see
1. Insert the unit into the rack, aligning the holes in the mounting flanges with those in
the rack.
2. Secure the processor to the rack using the supplied bolts.
figure 96
Quantum Ultra Videowall Processing System • HTML Operation
on the next page for an example):
101