Operation; Starting The Control Panel - Extron electronics Quantum Ultra Series User Manual

Operation

The Quantum Ultra processor is a host device with an embedded operating system. The
Quantum Ultra Control Panel is a program that resides on the Quantum Ultra operating
system and enables you to perform various setup and maintenance tasks, such as setting
the processor IP address, resetting the device, or updating the firmware.
This section discusses the functions accessed via the Control Panel:
•
•
•
•
•
•
•
•
•
•

Starting the Control Panel

To access the Quantum Ultra Control Panel:
1.
2.
Starting the Control Panel
Buttons on the Control Panel
Loading Image Files
Updating the Password
Updating Firmware
Modifying Network Settings from the Control Panel
Resetting the Device from the Control Panel
Service Mode
Disabling and Enabling Write Protection
Shutting Down the Device
Connect a USB keyboard and mouse to the USB system connectors on the rear
panel (see figure 39). You can also connect a USB flash drive to a USB system
connector to load and manage picture files or upload new firmware.
HDMI Out Port
for Monitor
Figure 39. System Ports for Keyboard, Mouse, and Monitor
Connect a monitor to the HDMI Out system connector on the rear panel. A login
window opens with the user name displayed (by default, this name is admin).
Quantum Ultra Videowall Processing System • Operation
SYSTEM
USB Ports for Keyboard,
Mouse, or Flash Drive
40