5.
6.
Replacing a Power Supply — Quantum Ultra 610
The Quantum Ultra 610 has a primary and a redundant power supply unit (PSU) to ensure
continued, uninterrupted operation if a power supply should fail. However, if a power
supply does fail, you should replace it at your earliest convenience. The power supplies
are hot-swappable, that is, one can be replaced while the unit is operating and the other
power supply is supplying power.
Replacing the Primary Power Supply
This section describes the procedure for replacing the primary power supply. If the
redundant power supply needs to be replaced, some additional steps are required (see
Replacing the Redundant Power Supply
Quantum Ultra Videowall Processing System • Maintenance — Quantum Ultra 610 Only
Use a screwdriver to tighten each thumbscrew on the card by pressing inward on the
screw head while rotating the screw clockwise until it is tight.
Figure 77.
Installing a New Input or Output Card
When finished removing and installing cards, power the unit on.
Align board and
slide into slot.
on page 88).
Thumbscrews
(2 per board)
84