Maintenance; Front Panel - Quantum Ultra 610; Accessing The Quantum Ultra 610 Front Panel - Extron electronics Quantum Ultra Series User Manual

Maintenance

The Quantum Ultra 610 has several parts that you can replace, should they fail, wear out,
or no longer meet your requirement. On the Quantum Ultra 305, only the input and output
cards can be replaced. The Quantum Ultra Connect models have no user-replaceable
parts, therefore, these maintenance procedures do not apply to them.
This section provides instructions for replacing these parts, which you can order from
your Extron representative or by going to www.extron.com. All these replacements are
performed from the front panel.
The following topics are discussed in this section:
•
•
•
•
•
•
Front Panel — Quantum Ultra 610

Accessing the Quantum Ultra 610 Front Panel

To access the Quantum Ultra front panel, open the front panel door as follows:
1.
2.
Quantum Ultra Videowall Processing System • Maintenance — Quantum Ultra 610 Only

Front Panel - Quantum Ultra 610

Replacing Input and Output Cards
Replacing a Power Supply - Quantum Ultra 610
Replacing the Power Supply Front Fan - Quantum Ultra 610
Replacing a Disk Drive - Quantum Ultra 610
Replacing the System Board Computer (SBC) Assembly - Quantum Ultra 610
Insert a coin, such as a penny, in the slot on the front panel lock and rotate it one
quarter turn counterclockwise, until the dot above the slot faces Open.
LOCK
LOCK
OPEN
OPEN
Figure 73. Front Panel Door Lock
Pull the front door all the way down (see figure 74 on page 80).
79