Quantum Ultra Connect 128 And 84; Hyperlane Bus For Source Transfer - Extron electronics Quantum Ultra Series User Manual

•
•
•
•

Quantum Ultra Connect 128 and 84

•
•
•
•
•

HyperLane Bus for Source Transfer

The HyperLane bus carries video source data between the input and output cards.
It allows the passage of up to 400 Gbps of video information, which translates to a
maximum of 96 native 1080p inputs at 60 Hz, or 24 4K sources at 60 Hz, all at 30 bits
per pixel.
The HyperLane bus delivers data in real time. This means that it is able to display a
source at its full temporal resolution, maintaining the same scan rate as the original source
without dropping any fields or frames. The HyperLane bus remains operational if an
operating system crash occurs, allowing crucial source content to be maintained on the
target display.
Selectable DTP, XTP matrix, and HDBaseT output modes (OUT4DTP card) —
Allows selection of the type of twisted pair technology best suited for the application.
Power insertion enables remote powering of DTP receivers (OUT4DTP
card) — 12 V DC insertion at the OUT4DTP output card enables the DTP receivers
to be powered over the twisted pair connections, eliminating the need for separate
power supplies at the remote units. Requires one PS 124 per OUT4DTP card.
Bidirectional RS-232 and IR insertion for AV device control (OUT4DTP card)
— Bidirectional RS 232 control and IR signals can be transmitted alongside the video
signal over DTP connections, allowing the remote device to be controlled without
the need for additional cabling. Bidirectional control insertion eliminates the need for
control system wiring to remote devices.
RS-232 insertion from the Ethernet control port (OUT4DTP card) — System
level device control to all remote locations via the Quantum Ultra control port,
providing comprehensive control of endpoints and attached devices without needing
additional equipment.
Cost effective 4K/60 HDMI videowall processors for videowalls with up to
eight screens
3U, 5-slot card frame
IN4HDMI input card supports signals up to 4K/60 — The IN4HDMI four-channel
input card accepts four signals from 1024x768 to 2048x1080 and 1920x1200 at
60 Hz. Dual-channel mode supports two single-path 4K/30 signals, while single-
channel mode supports one dual-path or quad-path 4K/60 signal. When used with
HDCP-compliant displays, HDCP 1.4-encrypted sources can be displayed on the
videowall.
OUT4HDMI output cards support signals up to 4K/60 — The OUT4HDMI four-
channel output cards delivers signals from 1024x768 to 2048x1080 and 1920x1200
at 60 Hz. Dual-channel mode supports two single-path 4K/30 signals, while single-
channel mode supports one dual-path or quad-path 4K/60 signal.
Up to 64 video and graphic windows per output card — Quantum Ultra Connect
offers extensive windowing capabilities, with the ability to display up to 64 video
windows from each output card.
Quantum Ultra Videowall Processing System • Introduction 6