Replacing A Disk Drive - Quantum Ultra 610 - Extron electronics Quantum Ultra Series User Manual

Replacing a Disk Drive — Quantum Ultra 610
The Quantum Ultra has two solid state hard disk drives:
•
•
One or both of these drives can be removed and replaced if they should fail during
operation.
NOTE: The System Board Computer (SBC) assembly contains the two disk drives
Figure 90.
ATTENTION:
To replace a disk drive:
NOTE: Before replacing a disk drive, confirm you have copies of the following files
1.
2.
Quantum Ultra Videowall Processing System • Maintenance — Quantum Ultra 610 Only
Drive C — Contains the internal operating system and hardware drivers (see
figure 90, ).
1
Drive D — Contains system configuration data. This drive can also store local source
content, such as image files (
and the system computer. This entire assembly can be removed and replaced if
necessary. However, it is not necessary to remove the entire SBC in order to replace
only the disk drives.
1 1 1 2 2 2
Disk Drives C and D
These drives are NOT hot-swappable and cannot be replaced while the unit is
•
operating. Always power off the Quantum Ultra before removing a drive.
Ces disques NE sont PAS interchangeables à chaud et il est impossible de les
•
changer durant le fonctionnement de l'unité. Mettez toujours hors tension le
Quantum Ultra avant de retirer un disque.
related to your Quantum Ultra system:
Project file currently loaded on the device
•
• Picture files currently loaded on the device
• Commissioning Report
Use VCS to connect to the unit and obtain the project file and commissioning report.
Picture files can be downloaded from the D drive of the unit using the System HDMI
and USB connections.
Shut down the unit and disconnect the power.
Use a screwdriver to loosen the thumbscrew on the drive (see figure 91,
next page) by rotating it to the left.
NOTE: The thumbscrews cannot be removed completely.
).
2
on the
1
93