Using The Command And Response Table; Symbol Definitions - Extron electronics Quantum Ultra Series User Manual

Using the Command and Response Table

The Command and Response Table for SIS Commands
commands that the Quantum Ultra processor recognizes as valid, the responses that are
returned to the host, a description of the command function or the results of executing the
command, and some examples of the command syntax in ASCII.
NOTE: Unless otherwise stated, upper- and lowercase text can be used
interchangeably in the commands.
ASCII to HEX Conversion Table
Space
Figure 63.

Symbol Definitions

• = Space
]
= Carriage return with line feed
} or |
= Carriage return with no line feed
E or W
= Escape
24 = Superscripts indicate the error message returned if the command is entered incorrectly
NOTE:
the command in any way.
X!
= Input selection —
Response is four digits with leading zeros.
0
1-999
1000-9999
X@
= Output number —
system) Response is four digits with leading zeros.
Examples:
X#
= Canvas selection — 1 through
Response is two digits with leading zero.
0
X$
= Source format
0
1
4
5
6
7
Quantum Ultra Videowall Processing System • Remote Configuration and Control
ASCII to Hexadecimal Character Conversion Table
or with invalid parameters (see
If the unit does not support or recognize an entered command, it may not respond to
1 through 9999
= window with no source
= Physical video connections on all chassis in the system
= VNC, image, and clock sources defined in the system
1011
through
1011
= device 1, card 01, connector 1
2994
= device 2, card 99, connector 4
10
= All canvases (for window mute and preset recall only)
= No signal present
= HDMI
= H.264/MJPEG
= VNC
= Clock
= Image file (.bmp, .jpg, .tif, or .png)
on page 61 lists the
.
Error Codes
on the previous page).
(assigned by VCS)
8994
(physical video connections on all chassis in the
57