Enable Alarms To Inads Via Snmp; Register The System - Avaya S8700 Installing Manual

Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway

Enable alarms to INADS via SNMP

NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device see (Avaya personnel only):
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
Click Start > Run to open the Run dialog box
1
2 Type telnet 192.11.13.6 and press
Log in as craft or dadmin (if business partner).
3
4 At the prompt type
. Where ipaddress is the trap receiver address for the SSG device and
Enter
community name is the community string name required by the SSG device.
5 Type almsnmpconf
entered.
6 At the prompt type
almenable and press
Type
7
enabled. If used, verify that alarm origination via modem is still enabled.

Register the system

Follow the existing process and procedures to register the Avaya
Let customers know what the default LAN security settings are; they may want to change them
after installation. Make sure they are aware that if the following items are not set, they will not
have remote access to the media servers:
telnet—no Telnet access
•
• https—no Web access
• def-sat—no SAT access
.
Enter
almsnmpconf -d ipaddress -c community name and press
and press . Verify that the correct information was
Enter
almenable -s y and press
Verify that the SNMP alarm origination is
Enter.
May 2003
Completing the Installation Administration
http://135.8.11.4/team-sra/
.
Enter
TM
S8700 Media Server.
229