Siemens Sinumerik 840D Operating Turning page 685

Complex programming example
Enter the following position values and press the
VSK 5 "Rapid traverse" to change the selection
feedrate to rapid traverse rate.
Acknowledge the inputs with the VSK 8 "Accept".
The following program block is added to the work
schedule.
13. Now programme a further rapid traverse motion.
Press the HSK 2.2 "Strght Circle" to gain access to
the function "Straight".
Press the VSK 2 "Straight".
The input mask for the technology "Straight" opens:
Enter the following position values and press the
VSK 5 "Rapid traverse" to change the selection
feedrate to rapid traverse rate.
Acknowledge the inputs with the VSK 8 "Accept".
The following program block is added to the work
schedule.
14. Now programme the measuring cycle "Workpiece
measure/Face CYCLE978".
For this press the HSK 2.6 "Measurem. milling" on
the extended horizontal softkey-strip.
The operating range "Measurement milling" with the
extended measuring functions opens.
Press the VSK 4 "Workpiece measure".
The vertical softkey-strip with functions for the meas-
uring of workpieces opens.
840D/828D SINUMERIK Operate
Section 3
Notes