Siemens Sinumerik 840D Operating Turning page 620

Section 3
Notes
B633
B633
Complex programming example
2. Accept your inputs by pressing the VSK 8 "Accept".
The following program block "Program header" will
inserted into the work plan:
3. Program the first contour description.
Press the HSK 1.4 "Cont. turn.", to open the function
"Contour turning".
Press the VSK 1 "New contour".
The "New contour" input mask opens where you can
enter a suitable name for the new contour.
4. Enter a name for the contour, e.g.
"SPIGOT_BLANK".
Accept your input by pressing the VSK 8 "Accept".
The operating area for the contour description
opens, with the input window for the starting point of
the contour active:
5. Enter the following values as the starting point:
Page 12 840D/828D SINUMERIK Operate