Siemens Sinumerik 840D Operating Turning page 500

Hide thumbs Also See for Sinumerik 840D:

Complex measurement example

Description:

An additional motion for measurement on the cylindrical surface of a pipe

is to be programmed with programGUIDE under ShopTurn.

A new G-code program is to be created and opened.

The G-Code lines and measuring cycles are programmed and

subsequently the program is to be simulated.

For this the tool data shown below are to be used:

3D-key (3D_PROBE_BLUM)

3.1 Programming example: Measuring a pipe internally and externally

The following program with the call-up of two measuring cycles is to be

For this create a new G-code programGUIDE-program under ShopTurn,

as described in section 2.1 of this module.

Name the program for example "DIN_MEASURE_MILLING_2.MPF".

In the first line programme the following G-code

N100 G54 G17 G90

Now add a 'Blank' for the simulation.

For this press the HSK 1.6 "Various" to call up the

work range "Various"

840D/828D SINUMERIK Operate

Sinumerik 828d