Siemens Sinumerik 840D Operating Turning page 471

Complex programming example
9. Program the following G code commands:
N200 M6
N210 G96 S150 M4
10. Insert another „Stock removal 2" cycle into the pro-
gram:.
Press the VSK 1 "Stock removal"
The work area for the technology "Stock removal"
opens.
Press the VSK 4 "Stock removal 2", to open the pa-
rameter mask for the "Stock removal 2" cycle ".
11. Insert the following values into the parameter mask:
Confirm your inputs by pressing the VSK 8 "Accept".
The following program line is inserted into the pro-
gram:
N220 CYCLE951(100,0,60,-60,60,-60,1,5,0.3,0.3,
21,0,5,5,1,0.15,1,2,0)
12.. Program the following G code command:
N230 G0 X200 Z200
13. Insert a new tool (ROUGHING_TOOL_A80) into the
program:
Press the VSK 1.1 "Select tool".
The tool list window opens.
Mark the desired tool (ROUGHING_TOOL_A80) in
the tool list window with the orange selection cursor.
Press the VSK 1.1 "To program".
The following program line is inserted into the pro-
gram:
N240 T="ROUGHING_TOOL_A80"
Optional you can program this line by hand.
840D/828D SINUMERIK Operate
Section 3
Notes