Siemens Sinumerik 840D Operating Turning page 470

Section 3
Notes
B634
B634
Complex programming example
8. Insert a "Stock removal 2" cycle into the program.
Press the VSK 2 "Stock removal"
The work area for the technology "Stock removal"
opens.
Press the VSK 3 "Stock removal 2", to open the pa-
rameter mask for the "Stock removal 2" cycle ".
9. Fill out the parameter mask like displayed below::
Confirm your inputs by pressing the VSK 8 "Accept".
The following program line is inserted into the pro-
gram:
N170 CYCLE951(100,0,60,-60,60,-60,1,5,0.3,0.3,
11,0,5,5,1,0.3,1,2,0)
10. Program the following G code line:
N180 G0 X200 Z200
8. Insert now a new tool (FINISHING_TOOL_35) into
the program:
Press the VSK 1.1 "Select tool".
The tool list window opens.
Mark the desired tool (FINISHING_TOOL_35) in the
tool list window with the orange selection cursor.
Press the VSK 1.1 "To program".
The following program line is inserted into the pro-
gram:
N190 T="FINISHING_TOOL_35"
Optional you can program the line by hand.
Page 10 840D/828D SINUMERIK Operate