Siemens Sinumerik 840D Operating Turning page 219

Position
7.3. Parameters of "Target position"
F [mm/
min]
[mm/
rev]
X [mm]
Y
Z
Z2
C [Degree] Target angle [abs/inc]
AWZ
SP2
7.4. Method for "Target position"
1. If required, select a tool.
2. Select the "JOG" operating mode.
3. Press the HSK 6 "Position".
4. Enter the target position or target angle for the axis
or axes to be traversed.
5. Specify the desired value for the feedrate "F".
- OR -
5. Press VSK 5 "Rapid".
*Rapid tr.* is displayed in the input field "F".
6. Press the "CYCLE START" button on the machine
control panel.
The axis is traversed to the specified target position.
If target positions were specified for several axes, the axes are traversed
simultaneously.
840D/828D SINUMERIK Operate
Feed
Target position [abs/inc]
Note:
The number of the axes is depending on the
machine configuration.
Note the machine manufacturer„s documen-
tation.
Section 7
Notes