Siemens Sinumerik 840D Operating Turning page 601

Complex programming example
2 Confirm your inputs by pressing the VSK 8 "Accept".
The following program block is inserted into the pro-
gram.
3. Program now the first stock removal cycle.
Press the HSK 1.3 "Turning".
Press the VSK 1 "Stock removal"
The work area for the technology "Stock removal"
opens.
Press the VSK 3 "Stock removal 1", to open the pa-
rameter mask for the stock removal cycle ".
4. Insert the following values into the parameter mask:
To insert a tool into the parameter mask, press the
VSK 1.1 "Select tool".
Mark the desired tool (ROUGHING_TOOL_A80) in
the tool list with the orange selection cursor and
press the VSK 1 "To program".
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block is inserted into the pro-
gram:
5. Program another stock removal cycle.
Press the VSK 1 "Stock removal".
The work area for the technology "Stock removal"
opens.
Press the VSK 4 "Stock removal 2", to open the pa-
rameter mask for the "Stock removal 2" cycle.
840D/828D SINUMERIK Operate
Section 3
Notes