Siemens Sinumerik 840D Operating Turning page 624

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

Finish the contour by pressing the VSK 8 "Accept".

The following program block "Contour" will be

inserted into the work plan:

The program chain opens.

Now, start a new contour.

Press the VSK 1 "New contour".

An input window opens where you can enter a suit-

able name for the new contour.

Fill out the input mask as follows:

Accept your input by pressing the VSK 8 "Accept".

The operating area for the contour description

opens, with the input window for defining the start-

point of the contour.

840D/828D SINUMERIK Operate

Sinumerik 828d