Siemens Sinumerik 840D Operating Turning page 235

Program control
5.2 Vertical softkey bar
Display area Description
Because there is no other selection possible the
softkey "General" is active by default.
By pressing the VSK 8 "Back" yo can switch back to
the "Program control" window.
5.3 Controlling the program run
1. In the operating mode "MDA" select the HSK 4
„Progr. cntrl.".
The "Program control" window opens.
2. Select the desired program control (see Section 5.1
in this module).
3. Press the VSK 8 "Back" to switch back to the main
screen of the SINUMERIC Operate in "MDA"-
operating mode.
840D/828D SINUMERIK Operate
Section 5
Notes