Siemens Sinumerik 840D Operating Turning page 587

Complex programming example
Description:
A more complex ShopTurn program (rectangular pocket) with the call up of
a rectangular pocket cycle, chained with a position is to be created.
Aim:
The milling machining shown below is to be programmed.
Afterwards the program is to be simulated.
The following tool- and technology data are needed for the programming:
Tool data: CUTTER_D8
Technology data: F = 0.030 mm/tooth
V = 220 m/min
Aim: A rectangular pocket is to be milled on the face side
of the blank.
840D/828D SINUMERIK Operate
Section 3
Notes