Siemens Sinumerik 840D Operating Turning page 677

Hide thumbs Also See for Sinumerik 840D:

Simple programming example

Enter the following position values and press the

VSK 5 "Rapid traverse" to change the selection

feedrate to rapid traverse rate.

Acknowledge the inputs with the VSK 8 "Accept".

The following program block is added to the work

Now programme the end of the program and simu-

late the measurement.

Place the orange-coloured cursor on the program

block "End-of-program" and extend the line by

pressing the key "Cursor to the right" on the CNC full

The input mask for the end of the program opens.

Here it is possible to select whether the program run

is to be repeated.

Leave the default value setting "no" and acknowl-

edge with the VSK 8 "Accept".

Change back to the horizontal softkey-strip 1 by

pressing the key "Extension" on the operator panel.

The horizontal softkey-strip 1 opens.

Press the HSK 1.7 "Simulation" in order to start the

simulation of the program.

The control unit evaluates the simulation and opens

the simulation window.

840D/828D SINUMERIK Operate

Sinumerik 828d