Adjusting The Maximum Ground Speed - Toro 31200 Operator's Manual

Figure 74
1. Transmission control rods
•
If the left rear tire is rotating in reverse,
lengthen the rod by slowly turning the rod
counterclockwise (as viewed from the front)
until the left rear tire stops rotating or has
minimal rotation in reverse.
•
If the left rear tire is rotating forward, shorten
the rod by slowly turning the rod clockwise
(as viewed from the front) until the left rear
tire stops rotating.
4. Move the throttle to the F
sure that the wheel remains stopped or has
minimal rotation in reverse. Adjust it as required.
5. Tighten the jam nuts.
6. Repeat the procedure for the right rear tire, if
required, by using the right-side transmission
control rod.
7. Shut off the engine, remove the jack stands, and
lower the machine to the shop floor.
8. Test drive the machine to make sure that it does
not creep.
g026002
position. Make
AST
Adjusting the Maximum
Ground Speed
1. Park the machine on a level surface, disengage
the PTO, release the traction pedal to the
N position, and engage the parking
EUTRAL
brake.
2. Move the throttle lever to the S
shut off the engine, remove the key from the
key switch, and wait for all moving parts to stop
before leaving the operating position.
3. Loosen the jam nut on the stop bolt for the
traction pedal
1. Traction pedal
2. Stop bolt with jam nut
(forward)
4. Adjust the stop bolt all the way in (away from
the traction pedal).
5. Using your hand, push the traction pedal all the
way forward, with light pressure, until it stops
and hold it there.
Note:
Maintain only light pressure on the pedal
when pushing it to the full forward position.
6. With the seat in the raised position, verify that
you are not over loading the linkage by making
sure the transmission does not move when you
press the pedal to the stop.
7. Adjust the stop bolt out (toward the traction
pedal) until there is a gap of 1.5 mm (0.060
inch) between the head of the stop bolt and the
bottom of the traction pedal.
8. Tighten the jam nut to secure the stop bolt in
place.
9. To change the reverse speed, you can adjust
the reverse stop bolt. To increase the reverse
59
position,
LOW
(Figure 75).
Figure 75
3. 1.5 mm (0.060 inch)
4. Stop bolt with jam nut
(reverse)
g014893