Cab Controls - Toro 31200 Operator's Manual

Power Point
The power point provides a 12 V power supply for
electronic devices (Figure
Important:
If the mower deck shuts down and
the InfoCenter temperature-warning icon is on,
push the PTO knob down; drive to a safe, flat
area; move the throttle lever to the S
allow the traction pedal to move to the N
position; and engage the parking brake. Allow the
engine to idle for several minutes while it cools to
a safe level. Shut off the engine and check the
cooling system; refer to
System (page 55).
Fuel Gauge
The fuel gauge (Figure
remaining in the fuel tank.
1. Fuel gauge
7).
position;
LOW
EUTRAL
Checking the Cooling
8) indicates the fuel level
Figure 8
2. Fuel-tank cap

Cab Controls

Model with Cab Only
1. Fan control
2. Temperature control
3. Windshield-wiper switch
Air-Recirculation Control
Sets the cab to either recirculate the air in the cabin or
to draw air into the cabin from outside
•
Set it to recirculate the air when using the
air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan-Control Knob
Rotate the fan-control knob to regulate the speed of
g014170
the fan (Figure
Temperature-Control-Knob
Rotate the temperature-control knob to regulate the
air temperature in the cab
Windshield-Wiper Switch
Use this switch to turn the wind shield wipers on or
off (Figure 9).
Air-Conditioning Switch
Use this switch to turn the air conditioning on or off
(Figure 9).
Windshield Latch
Lift up the latch to open the windshield
Press in the latch to lock the windshield in the open
position. Pull out and down on the latch to close and
secure the windshield.
15
Figure 9
4. Air-conditioning switch
5. Air-recirculation control
9).
(Figure 9).
g198816
(Figure 9).
(Figure 10).