Adjusting The Blade Speed; Shutting Off The Machine - Toro 22232 Operator's Manual

Adjusting the Blade Speed

This machine has 3 blade-speed settings: A
and L .
OW
•
When set to the A
UTO
is adjusted automatically for greater efficiency;
changes in cutting conditions are detected and
the blade speed increases when necessary to
maintain quality of cut.
•
When set to the M
AX
remains at the highest speed at all times. The
traction speed of the machine also increases.
•
When set to the L
OW
remains at the lowest speed at all times. The
traction speed of the machine also decreases.
Turn the electric-start button in the electric-start switch
to adjust the blade speed setting

Shutting Off the Machine

1. Release the blade-control bar (A of
2. Remove the electric-start button from the electric-start switch (B of
3. Remove the battery pack; refer to
Note:
Whenever you are not using the machine, remove the battery pack.
UTO
position, the blade speed
position, the blade speed
position, the blade speed
(Figure 16).
Figure
Removing the Battery Pack from the Machine (page
, M ,
AX
1. L position
OW
2. A position
UTO
17).
Figure 17
16
Figure 16
3. M position
AX
Figure 17).
20).
g427663
g427664