Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Parts Catalog
Operator training material
1
Installing the PTO
Driveshaft to an Optional
Mower Deck or QAS
Parts needed for this procedure:
1
PTO driveshaft
4
Bolt (5/16 x 1-3/4 inches)
4
Locknut (5/16 inch)
2
Roll pin (3/16 x 1-1/2 inches)
Procedure
Note:
Installing the PTO driveshaft is easier if you
position the machine on a hoist.
Description
PTO driveshaft
Bolt (5/16 x 1-3/4 inches)
Locknut (5/16 inch)
Roll pin (3/16 x 1-1/2 inches)
Retainer pin
Grease fitting
Washer head screw (5/16 x 7/8 inch)
No parts required
No parts required
No parts required
Qty.
1
4
4
2
2
2
2
–
–
–
Qty.
1
Read the manual before operating the machine.
1
Read the manual before operating the machine.
1
Use the Parts Catalog to reference part numbers.
1
Review before operating machine
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key from the key switch.
WARNING
Do not start the engine and engage the
PTO switch when the PTO driveshaft is
disconnected from the cutting deck. If
you start the engine and the PTO shaft
is allowed to rotate, serious personal
injury and machine damage could
result. Before the PTO driveshaft is
disconnected from the cutting deck,
disconnect the PTO solenoid-valve-coil
connector from the wire harness to
prevent unintentionally engaging the
PTO clutch.
2. Disconnect the wire-harness connector from the
PTO solenoid-valve-coil connector
11
Use
Install the PTO driveshaft to a optional
deck or QAS.
Use the hardware to install the optional
mower deck.
Adjust the roll bar.
Check the tire pressure.
Check the levels of the hydraulic fluid,
engine oil, and coolant.
Use
(Figure
3).