Table of Contents
Advertisement
3. Install the expansion-tank cap.
1. Expansion tank
Cleaning the Radiator
Service Interval: Before each use or daily Clean the
radiator more frequently in extremely
dusty and dirty conditions.
Keep the radiator clean to prevent the engine from
overheating.
Note:
If the attachment or engine shuts off due to
overheating, first check the radiator for an excessive
buildup of debris.
1. Open the hood and secure the prop rod.
2. Loosen the flange nut securing the clean-out
cover to the underside of the rear frame
70). Rotate the cover to the side to expose the
clean-out hole in the frame.
1. Clean-out cover
3. Working from the fan side of the radiator,
blow out debris with low-pressure (50 psi)
Figure 69
Figure 70
compressed air (do not use water). Repeat this
step from the front of the radiator, again from
the fan side.
4. After you have thoroughly cleaned the radiator,
remove any debris from the channel at the
radiator base and around the frame.
5. Clean the engine compartment and the brake
linkage.
6. Close the clean-out cover and secure the flange
nut.
7. Close the hood.
g014268
(Figure
G014515
g014515
56
Advertisement
Table of Contents
