Product Overview; Controls - Toro 31200 Operator's Manual

Product Overview

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. The ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop the machine, reduce the foot pressure on
the traction pedal and allow it to return to the center
position.
1. Parking brake
2. Brake pedal
Brake Pedal
Use the brake pedal with the brake-pedal latch to
engage and disengage the parking brake
6). To stop the machine, release the traction pedal
and allow it to return to the center position. You can
use the brake to assist in stopping the machine in an
emergency situation.
Parking Brake
To engage the parking brake, push down on the brake
pedal and press the top forward to latch it
6). To disengage the parking brake, press the brake
pedal until the parking-brake latch retracts.
6) controls the forward and
position.
AST
Figure 6
3. Tilt-steering pedal
4. Traction pedal
(Figure
(Figure
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down and pull the steering tower toward you to
the most comfortable position and then release the
pedal (Figure 6).
Engine-Speed Switch
The engine-speed switch
change the engine speed. By momentarily tapping
the switch, you can increase or decrease the engine
speed in increments of 100 rpm. Press and hold the
switch to set the engine speed directly to high or low
idle, depending on which end of the switch you press.
1 2
7 6
1. InfoCenter
2. Power-takeoff (PTO)
switch
3. Engine-speed switch
4. Steering selector switch
g197397
InfoCenter
The InfoCenter LCD display shows the operating
status, various diagnostics, and other information
about the machine
Key Switch
The key switch has 3 positions: O
and S (Figure
TART
Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
attachment (Figure
Steering Selector Switch
4-Wheel Drive Machines Only
Press the steering selector switch to the rear to
engage 4-wheel steering and forward to return to
2-wheel steering
14
(Figure 7) has 2 modes to
3 4
5
Figure 7
5. Power point
6. Key switch
7. Deck-lift switch
(Figure 7).
, O
FF N
7).
7).
(Figure 7).
G026098
g026098
/P ,
REHEAT