Table of Contents
Advertisement
3. Install the 2 pins and secure them with the
hairpin cotters
(Figure
Important:
Ensure that the seat is secured
with the seat latch.
4. To raise the roll bar, remove the hairpin cotter
pins and remove the 2 pins
5. Raise the roll bar to the upright position and
install the 2 pins and secure them with the
hairpin cotters
(Figure
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Starting and Shutting Off
the Engine
Starting the Engine
1. Park the machine on a level surface.
2. Raise the roll bar up and lock it into place, sit on
the seat, and fasten the seat belt.
3. Make sure that the traction pedal is in the
N
position.
EUTRAL
4. Engage the parking brake.
5. Move the power-takeoff (PTO) switch to the O
position
(Figure
1. InfoCenter
2. Power-takeoff (PTO)
switch
6. Turn the key clockwise to the R
Note:
The InfoCenter glow-plug icon turns on
in 6 seconds.
7. After the InfoCenter glow-plug icon goes out,
turn the key to the S
engine starts, release the key.
21).
(Figure
21).
21).
22).
Figure 22
3. Engine-speed switch
4. Key switch
position.
UN
position. When the
TART
Important:
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
required when starting the engine for the first
time after the fuel system has been completely
drained.
Important:
the first time, or after an engine oil change or
an overhaul of the engine, the transmission,
or a wheel motor, operate the machine with
the engine-speed switch in the Slow position
in both the forward and reverse directions
for 1 to 2 minutes. Also operate the deck
lift switch and the PTO switch to ensure
proper operation of all the parts. Then shut
the engine off and check the fluid levels
and check for oil leaks, loose parts, and any
other noticeable malfunctions.
Shutting Off the Engine
1. Park the machine on a level surface.
2. Disengage the PTO, make sure that the traction
pedal is in the N
parking brake, and move the engine-speed
switch to the idle position.
3. Let the engine idle for 60 seconds.
FF
4. Turn the key to the
5. Remove the key from the key switch before
transporting or storing machine.
Important:
key switch; otherwise, the fuel pump or
accessories may run and cause the battery
to lose charge.
Children or bystanders may be injured
if they move or attempt to operate the
machine while it is unattended.
g026090
g026090
Always remove the key from the key
switch and engage the parking brake
when leaving the machine unattended,
even if just for a few minutes.
Driving the Machine
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate the throttle in the F
position when mowing.
28
Use starting cycles of no
Additional starting cycles may be
When you start the engine for
position, engage the
EUTRAL
position.
OFF
Remove the key from the
CAUTION
position for best
AST
AST
Advertisement
Table of Contents
