Avaya S3210R Manual page 52

To install switch connection software:
1. Log in to the system.
2. Start at the Administration menu, and select Utilities > Software Management > Software Installation.
3. Switch connection software is included on the Message Networking software CD. Obtain the CD, then
follow the on-screen instructions to insert the CD.
4. Click CD (or another installation media if applicable).
5. The system warns you that system data should be backed up. If necessary, perform a system backup. If
the system is new, no data needs to be backed up.
The system displays a list of packages available on the CD, including the two switch integration
packages: SWINSet and LANSet.
6. Select the switch integration package you want to install.
7. Press PageDown to see the bottom of the page, and click Install selected packages.
The system displays a list of packages to be installed.
8. Review the list, then click Proceed with installation.
The system begins the installation and displays installation status messages. The installation is complete
when the pointer changes from a wristwatch to an arrow.
9. After the software is installed, press PageDown to see the bottom of the status page.
10. If the software was installed successfully, remove the CD from the CD drive.
11. Click Restart the System.
The system begins the restart. During the restart, login prompts display. Do not log in at these prompts as
the system is not ready.
12. When the system displays the message "ICHG Module Started," press Enter and then log in to the
system.
13. If you are restoring an existing system, go to
Top of page
Performing a restore.
52