Avaya S3210R Manual page 26

do not have any EBM units, go to step 2.
b. Install the EBM brackets by aligning each bracket with the screw holes. Secure the bracket the
supplied screws as shown in
c. Repeat steps 1 and 2 for each additional EBM.
2. On the bottom unit (UPS or EBM), secure four rubber spacers to the bottom of the unit, one at each
corner.
3. Set the unit on a stable server. This unit will form the base of the server configuration.
4. If you are installing an S3400-H, continue with the
Cabling the UPS and any EBMs (S3400-H only)
To cable the UPS and any EBM units:
1. Connect the EBM cable to the battery connector on the UPS. See item 1 in
EBM (back view).
2. If you must connect additional EBMs, plug the EBM cable of the second EBM into the battery connector
on the first EBM.
3. Repeat step 2 for each additional EBM. Up to four EBMs can be connected to the UPS.
Top of page
Connecting brackets between a stacked UPS and
Cabling the UPS and any
EBM.
EBMs.
Connecting a UPS and an
26