Braking System - PIAGGIO Beverly 125 Service Station Manual

Maintenance

Braking system

Level check
The brake fluid tanks for the front and rear brakes
are located on the pumps under the handlebar
cover. Proceed as follows:
- Bring the scooter onto the centre stand and with
the handlebar centred; - check the fluid level at the
sight glass as shown in the figure.
A certain lowering of the level is caused by wear
on the pads.
Top-up
- Remove the cap on the handlebar cover as
shown in the photograph.
- Remove the tank cap by loosening the two
screws, remove the gasket and top up using only
the liquid specified without exceeding the maxi-
mum level.
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
CAUTION
AVOID CONTACT OF THE BRAKE FLUID WITH YOUR
EYES, SKIN, AND CLOTHING. IN CASE OF ACCIDENTAL
CONTACT, WASH WITH WATER.
CAUTION
BRAKING CIRCUIT FLUID IS HIGHLY CORROSIVE; MAKE
SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
THE BRAKE FLUID IS HYGROSCOPIC, IN OTHER WORDS,
IT ABSORBS MOISTURE FROM THE SURROUNDING AIR.
IF THE CONTENT OF MOISTURE IN THE BRAKING FLUID
MAIN - 48
Beverly 125