Front Brake Calliper - PIAGGIO Beverly 125 Service Station Manual

Beverly 125
Refitting
- Fix the brake calliper support plate to the crank-
case and the brake calliper to the bracket, tight-
ening the screws to the prescribed torque.
- Apply the recommended product to the fixing
screws of the brake calliper to the bracket.
- Purge the system.
N.B.
WHILE REFITTING, REPLACE THE COPPER GASKETS ON
THEIR FITTINGS.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Oil bleed screw
12 - 16
to the support
23 ÷ 25
calliper support to engine
pipe-calliper fitting
16 ÷ 20
See also
Rear - combined

Front brake calliper

Removal
- Inspect the condition of the hoses, packing and
joint. In the event of fluid leaks from the calliper,
this must be replaced.
- Detach the oil brake pipe from the calliper; pour
the fluid inside a container.
- Remove the clamps shown in the figure.
Screw tightening calliper
Screw fixing rear brake
Brake fluid
20 ÷ 25
Braking system
BRAK SYS - 191