PIAGGIO Beverly 125 Service Station Manual page 75

Beverly 125
If no voltage is detected, check the cable harness,
the connections and make sure the 15A main fuse
(No. 7) is in good conditions; otherwise, proceed
as follows:
- Jump terminals No. 1 (Blue-Black) and No. 4
(Red-Black) (see figure) and turn the turn indicator
switch alternately to the right and left. Make sure
the lights turn on.
If they do, replace the control unit because it is
faulty. If they do not turn on, check the control unit-
turn indicator switch connection cable harness;
then, repeat the test.
If the cable harness is in good conditions and the
turn indicators still do not turn on, replace the turn
indicator switch because it is faulty.
Lights list
1
2
3
4
5
6 Helmet compartment light bulb
7
LIGHT BULB TABLE
Specification
High-beam light bulb
Low-beam bulb
Front tail light bulb
Instrument panel bulb
Front turn indicator bulb
Rear turn indicator bulb
Electrical system
Desc./Quantity
Type: HALOGEN (H7)
Power: 12V - 55W
Quantity: 1
Type: HALOGEN (H1)
Power: 12V - 55W
Quantity: 1
Type: ALL GLASS
Power: 12V - 5W
Quantity: 2
Type: ALL GLASS
Power: 12V - 1.2W
Quantity: 5
Type: SPHERICAL
Power: 12V - 10W
Quantity: 1 RHS + 1 LHS
Type: CYLINDRIC
Power: 12V - 5W
Quantity: 1
Type: SPHERICAL
ELE SYS - 75