PIAGGIO Beverly 125 Service Station Manual page 208

Cooling system
- Insert the flywheel cover with bearings on the ap-
propriate tool.
- Insert the shaft together with the mechanical gas-
kets on the bearings.
- With the appropriate punch and socket, insert the
shaft in the bearings and the drive until the end of
stroke of the appropriate tool cannot be seen.
- Reassemble the rotor cover with a new O-Ring.
- Tighten the 3 fixing screws to the torque below.
N.B.
AVOID OVERHEATING AS THIS MAY ALTER THE PAIN-
TED SURFACE.
N.B.
ALWAYS USE NEW BEARINGS.
N.B.
ALWAYS USE NEW CERAMIC RING AND GASKETS. AS-
SEMBLING THE CERAMIC SEALING RING IN A MANNER
OTHER THAN MANUALLY MAY DAMAGE THE RING.
N.B.
Centre the punch well on the rotor. Push the shaft in and check
that the wheel flywheel cover is level. Failure to respect this
procedure damages the drive.
N.B.
DO NOT LUBRICATE THE O-RING. FAILURE TO RESPECT
THIS RULE RESULTS IN RING DISTORTION.
Specific tooling
020440Y Water pump service tool
Locking torques (N*m)
Water pump rotor cover
COOL SYS - 208
3 ÷ 4
Beverly 125