PIAGGIO Beverly 125 Service Station Manual page 82

Engine from vehicle
- Remove the rear brake calliper and release the
hoses from the scooter.
- Remove the left shock absorber lower retainer.
- Remove the throttle grip transmission.
- Detach the air filter sleeve and the manifold
shown in the figure.
- Detach the engine ground lead.
- Disconnect the carburettor electrical devices and
the starter motor power supply cable.
- Disconnect the delivery and reverse fuel pipes
from the carburettor and the cooling system piping
(out from the head and into the thermostat).
- Disconnect the spark plug HV wire.
- Disconnect the generator cable harness from the
scooter electrical system.
- Remove the swinging arm from the engine re-
tainer.
- The engine is now free.
WARNING
CARRY OUT THESE OPERATIONS WHEN THE ENGINE IS
COLD
WARNING
BE VERY CAREFUL WHEN HANDLING FUEL.
CAUTION
WHEN INSTALLING THE BATTERY, ATTACH THE POSI-
TIVE LEAD FIRST AND THEN THE NEGATIVE LEAD.
- When refitting the engine on the scooter, carry out the removal operations but in reverse order and
respect the locking torques indicated in the Characteristics Chapter.
-Check the engine oil level and if necessary top it up with the recommended type.
- Top-up the cooling circuit.
- Check the functioning of the accelerator and the electrical devices.
CAUTION
PAY PARTICULAR ATTENTION TO POSITIONING THE THROTTLE CONTROL TRANSMISSION
PROPERLY. CHECK THAT THERE IS A SMALL CLEARANCE WHEN THE VALVE IS IN ABUT-
MENT AGAINST THE SET SCREW.
See also
Side fairings
Removal
Exhaust assy. Removal
Removing the rear wheel
Seat
Footrest
Swing-arm
ENG VE - 82
Beverly 125