Rear Brake Disc - PIAGGIO Beverly 125 Service Station Manual

Beverly 125
The body and the reaction plate body work inte-
grally and can move axially with respect of the
fixed plate that is integral to the strut.
The pistons, forced by pressure to push the pad to
the disk, cause the reaction plate to push in turn
the other pad towards the disc.
The brake pad lock spring
1. Pad fixing screws
2. Reaction plate fixing screws
3. Reaction plate
4. Fixed plate
5. Floating body
6. Piston
7. Piston sealing rings
8. Guide protection rubbers
9. Brake pad check spring
10. Pads
CAUTION
ALL THE SEALS AND GASKETS MUST BE REPLACED EV-
ERY TIME THE CALLIPER IS SERVICED.
Locking torques (N*m)
Brake fluid pipe-calliper fitting
tening pin
19.6 ÷ 24.5
Refitting
- When refitting, tighten the nuts to the prescribed
torque.
- Purge the system.
N.B.
WHILE REFITTING, REPLACE THE COPPER GASKETS ON
THEIR FITTINGS.
Locking torques (N*m)
Oil bleed screw
12 - 16
to the support
20 ÷ 25
fitting
16 ÷ 20
See also
Front

Rear brake disc

Pad fas-
20 ÷ 25
Screw tightening calliper
Brake fluid pipe-calliper
Braking system
BRAK SYS - 193