PIAGGIO Beverly 125 Service Station Manual page 182

Suspensions
- In order to check the clearance of the swinging
arm on the frame side, prepare a retainer using the
fixing pin of the swinging arm on the frame and two
rings from the special tool 020229Y.
Alternatively, use two washers with inside diame-
ter of 12 mm for pins, outside diameter min. 30 mm
and thickness min. 4 mm.
- Separate the swinging arm on the engine side
from the vehicle side arm.
- Remove the internal spacer shown in the photo-
graph
- Using a suitable pin remove the roller casings as
shown in the photographs
SUSP - 182
Beverly 125