PIAGGIO Beverly 125 Service Station Manual page 217

Beverly 125
Removing the ignition key-switch when on *lock*
In position "Lock", it is not possible to access the
cylinder retaining spring. The spring must then be
removed as shown in the figure, allowing the lock
spring to be pressed out.
N.B.
TO REFIT THIS ITEM, THE SCOOTER STEERING LOCK
MUST BE RELEASED WITH THE LOCK BODY (INTERNAL
AND EXTERNAL PART) IN POSITION "OFF". PROCEED AS
DESCRIBED IN THE PREVIOUS PARAGRAPH.
See also
Removing the ignition key-switch when on *off*
Front wheel housing
- Remove the shield back plate.
- Remove the footrests.
- Remove the front suspension.
- Loosen the remaining retaining screws holding
the central chassis cover.
- Remove the radiator cover.
See also
Knee-guard
Removing the front wheel
Footrest
Taillight assy.
- Remove the cover of the luggage rack (snapped-
in).
- Remove the side bumpers.
- Unscrew the 3 screws holding the rear light.
- Remove the rear light assembly after disconnect-
ing the electrical cable harness.
See also
Side fairings
Chassis
CHAS - 217