PIAGGIO Beverly 125 Service Station Manual page 214

Chassis
Headlight assy.
- Remove the headlight assembly by loosening the
4 fixing screws, two of which are shown in the fig-
ure and two located further down. - Separate the
electrical connectors; - Pull out the headlight as-
sembly.
Frame central cover
- Open the fuel tank access port.
- Loosen the 4 screws shown in the figure.
- At the same time, remove the fuel tank cap.
Remove the frame central cover by sliding it from
the rear side of the scooter and disconnecting it
from the cover opening transmission.
Legshield
- Remove the headlight assembly.
- Remove the central frame cover.
- Remove the fixing screw of the expansion tank
access cover.
- Loosen the 2 fixing screws on the upper part of
the shield back plate, one of which is shown in the
figure.
- Undo the remaining 2 fixing screws of the leg-
shield with the wheel housing.
CHAS - 214
Beverly 125