Crankcase - Crankshaft - PIAGGIO Beverly 125 Service Station Manual

Engine
Slider screw
Refitting the rocker-arms cover
- Refit the cylinder head cover, tightening the 5
clamping screws to the prescribed torque.
- Make sure the gasket is positioned properly.
Locking torques (N*m)
Tappet cover screws
Refitting the intake manifold
Fit the intake manifold and do up the three screws.
N.B.
FOR SPECIAL SCREWS USE COMMERCIALLY AVAILA-
BLE INSERTS AND INSERT HOLDERS.

Crankcase - crankshaft

Splitting the crankcase halves
First remove the following units:
transmission cover, driving pulley, driven pulley and belt, rear hub cover, gears, bearings and oil seals
as described in the transmission chapter.
- Remove the oil sump, the by-pass, the chain compartment cover and the oil pump as in the lubrica-
tion chapter.
- Remove the flywheel cover together with the water pump, the flywheel and the stator as described in
the magneto flywheel chapter.
- Remove the oil filter and the oil pressure switch.
- Remove the cylinder/piston/head unit as described in the cylinder head timing system chapter.
- Remove the two retainers indicated in the figure and the starter motor.
ENG - 134
Name
6 - 7 Nm
Beverly 125
Torque in Nm
10 ÷ 14 Nm