Table of Contents
Advertisement
Braking system fluid top up (03_16, 03_17)
Instructions refer to one braking system only, but they are valid for both.
Remove the rear-view mirror undoing the nut «A» and remove the plastic cover «B».
Unscrew the two screws «C», remove the fuel tank cap and the intermediate rubber
membrane, and top-up the brake fluid level only with the recommend brake fluid type
and without exceeding the maximum level.
Under standard climatic conditions, replace coolant as indicated in the scheduled
maintenance table. This operation must be carried out by trained technicians; take
your scooter to an authorised Service Centre or Dealer.
03_16
WARNING
ONLY USE DOT 4 CLASS BRAKE FLUIDS. COOLING SYSTEM FLUIDS ARE
HIGHLY CORROSIVE. MAKE SURE THAT IT DOES NOT COME INTO CONTACT
WITH THE PAINTWORK
.
CAUTION
03_17
AVOID CONTACT OF BRAKE FLUID WITH EYES, SKIN, AND CLOTHING. IN
CASE OF CONTACT, RINSE WITH WATER. THE BRAKING CIRCUIT FLUID IS
HYGROSCOPIC, THAT IS, IT ABSORBS HUMIDITY FROM THE SURROUNDING
AIR. IF THE HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN VALUE,
IT WILL LEAD TO INEFFICIENT BRAKING. NEVER USE BRAKING FLUID KEPT
IN CONTAINERS THAT HAVE ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
AGIP BRAKE 4
Brake fluid
FMVSS DOT 4 Synthetic fluid
47
Advertisement
Table of Contents
