PIAGGIO Beverly 125 Service Station Manual page 44

Maintenance
Replacement
Change oil as indicated in the scheduled mainte-
nance table. The engine must be emptied by drain-
ing the oil through the drainage plug «B» of the
mesh pre-filter, flywheel side; furthermore, to fa-
cilitate oil drainage, loosen the cap/dipstick «A».
Once all the oil has drained through the drainage
opening, unscrew and remove the oil cartridge fil-
ter «C ».
Since a certain quantity of oil still remains in the
circuit, fill adding approx. 600 ÷ 650 cm³ of oil
through the cap «A». Then start up the scooter,
leave it running for a few minutes and switch it off:
After about five minutes, check the level and, if
necessary, top-up but never exceeding the MAX
level reference mark.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Locking torques (N*m)
Engine oil drainage plug
See also
Engine
oil filter
Check
In 4T engines, the engine oil is used to lubricate the distribution elements, the bench bearings and the
thermal group. An insufficient quantity of oil can cause serious damage to the engine. In all 4T
engines, the deterioration of the oil characteristics, or a certain consumption should be considered
normal, especially if during the run-in period. Consumption can particularly reflect the conditions of use
(i.e. when driving at 'full acceleration' all the time, oil consumption increases).
MAIN - 44
24 ÷ 30
Beverly 125